Kramer-electronics VP-773AMP Instrukcja Użytkownika Pobierz pdf (Strona 78)

VP-773AMP - The VP-773AMP RS-232 Communication Protocol

Network settings commands

Network settings commands require admin authorization

Command

Syntax

Response

DHCP_MODE =

0 (factory default) – Don't use DHCP (Use IP set by factory or IP set command).

1 – Try to use DHCP, if unavailable use IP as above.

2– Try to use DHCP, if unavailable use AUTO-IP as described here:

http://support.microsoft.com/kb/q307287/ .

Change

protocol

Ethernet port

ETH-PORT PROTOCOL , PORT

ETHP

ETH-PORT PROTOCOL ,PORT

RESULT

Read protocol

Ethernet port

ETH-PORT? PROTOCOL

ETHP?

ETH-PORT PROTOCOL , PORT

PROTOCOL = TCP / UDP (transport layer protocol)

PORT =

Ethernet port to enter protocol 3000 commands.

1-65535 = User defined port

0 - reset port to factory default (50000 for UDP, 5000 for TCP)

Load new

peripheral

firmware P

Step 1: LDFW SIZE

Response 1: READY or LDFW SIZE ERR###

Step 2: If ready was received, send FIRMWARE_DATA

Response 2: LDFW SIZE RESULT

Load new video

core firmware

Step 1: LDFWS SIZE

Response 1: READY or LDFWS SIZE ERR###

Step 2: If ready was received, send FIRMWARE_DATA

Response 2: LDFWS SIZE RESULT

Load new

audio/graphic

memory file

Step 1: LDMFS SIZE

Response 1: READY or LDMFS SIZE ERR###

Step 2: If ready was received, send FIRMWARE_DATA

Response 2: LDMFS SIZE RESULT

1 2 ... 73 74 75 76 77 78 79 80

Komentarze do niniejszej Instrukcji

Brak uwag

Kramer-electronics VP-773AMP Instrukcja Użytkownika Strona 78

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Kramer-electronics VP-773AMP