Kramer-electronics PL-50 Instrukcja Użytkownika Pobierz pdf (Strona 13)

Connecting the PL-50 Power Controller - Monitor

6.1 Connecting the Relays

Figure 5 shows how to connect the relay.

To Alarm

Figure 5: Relay Wiring

On each 3-pole terminal block connector, connect either: C to NC, or C to

NO.

Table 3 defines the Relay PINOUT:

Table 3: Relay PINOUT

RELAY PINOUT

C Common

NO Normally Open (relay is open by default and closes for activation)

NC Normally Closed (relay is closed by default and opens for activation)

6.2 Controlling the PL-50 via the Ethernet Port

You can connect the PL-50 via the ETHERNET in the following ways:

• For direct connection to the PC, use a crossover cable (see section

6.2.1)

• For connection via a network hub or network router, use a

straight-through cable (see section

6.2.2)

6.2.1 Connecting the ETHERNET Port Directly to a PC (Crossover Cable)

You can connect the Ethernet port of the PL-50 to the Ethernet port on your

PC, via a crossover cable with RJ-45 connectors.

This type of connection is recommended for identifying the PL-50

with the factory configured default IP address

After connecting the Ethernet port, configure your PC as follows:

1. Right-click the My Network Places icon on your desktop.

2. Select Properties.

3. Right-click Local Area Connection Properties.

4. Select Properties.

The Local Area Connection Properties window appears.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Brak uwag

Kramer-electronics PL-50 Instrukcja Użytkownika Strona 13