Kramer-electronics SID-X1 Instrukcja Użytkownika Pobierz pdf (Strona 13)

10 SID-X1 - Connecting the SID-X1

5.3 Connecting the Remote Input Selection LEDs

You can connect remote, input selection LEDS to the LED terminal block on the

rear panel of the SID-X1 to indicate which is the active input.

Figure 6 illustrates the connections from the terminal block to the LEDs.

Figure 6: Remote Input Indicator LED Wiring

To connect remote input indicator LEDs:

1. Connect pin 1 from the terminal block to the anode of the remote HDMI

indicator LED.

2. Connect pin 2 from the terminal block to the anode of the remote DP

indicator LED.

3. Connect pin 3 from the terminal block to the anode of the remote DVI

indicator LED (see the example in

Figure 7).

4. Connect pin 4 from the terminal block to the anode of the remote UXGA

indicator LED.

5. Connect pin 5 from the terminal block to the cathodes of each LED.

Figure 7: Example Remote Input Indicator LED Wiring for the DVI Input

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Brak uwag

Kramer-electronics SID-X1 Instrukcja Użytkownika Strona 13